TSB Heavy Duty Shield Anchor
Description
Medium to heavy duty metal expansion sleeve for use in concrete and masonry. Can also be used with threaded studs as required.
​
Materials
-
Carbon and Alloy Steels AISI C 1022, Hardened - Zinc Plated
-
Stainless Steels Grades A2,A4 according to ISO 3506 on request
​
Dimensions​
Performance Data
Recommended Resistance
Loads indicated are for a single anchor without consideration of center to center spacing and distance to the edge if any.
Installation information
*For plastered walls the drill depth and bolt length must be increased corresponding to the thickness of the plaster.
​
​Installation procedure
Equipment
-
Drilling machine
-
Drill bit of diameter matching anchor size
-
Hammer
-
Wrench with matching drive socket
-
Air blower or compressed air with nozzle
-
Person Protection Equipment (PPE) including gloves.
1. Drill holes in the base material of the required diameter and depth.
2. Blow the dust and debris out of the holes.
3. Tap the anchor into the hole until flush with surface
4. Bring the fixture into position.
5. Screw the bolt through the washer and fixture into the anchor.
6. Using the wrench, tighten the bolt until flush. Do not over tighten as this may damage the fixture.
7. Repeat the process until all the required number of anchors have been installed. The fixture can now be loaded.